Margarita Glow – Tealight & LED Lamp

A margarita-inspired LED lamp and  LED tealight holder, designed to bring a fun summer glow to any party, table, bar, kitchen, or patio setup.

New base – 2 in 1 solution. You can now use it with Bambu LED Lamp Kit-001 OR a LED Tealight

The base is designed with for dual light source options, LED lamp kit and LED Tealights. The new base still fits with the previous released votives. 

 It's designed with a Lockable base system – the votive securely twists into the base so it can easily be moved around and changed.

The base is designed to change with other votives for seasonal decor. For more votive designs to change with, go here: https://makerworld.com/en/collections/23448086-tealight-holders

*Only intended for LED lights.

Lamp kit and LED Tealight suggestions:

MH001-LED Lamp Kit: https://us.store.bambulab.com/products/led-lamp-kit-001?id=41806987395208

KC018 Warm White LED Flame Teal Light Candle Set: https://us.store.bambulab.com/products/led-flame-tea-light-candle-set-warm-yellow?id=42892871925896

Alternative

Lamp kit (dimmable and color changing options): https://www.amazon.com/dp/B0GTNZ1FXW?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

Rechargeable Tealight: https://www.amazon.com/dp/B0F3D2LMZB?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_4&th=1

Perfect For:

• Party Decoration
• Bars
• Summer Party
• Table Decoration 

• Hostess Gift

   

Size

Height: ~9cm

With: ~7cm

Printing

• Designed in Fusion 360 for reliable printing
• Use a clean print plate with some glue (unless you are using a super tack plate)
• Use dried out filament
  • (Different filament types impact the print differently, please adjust your settings accordingly)
• No support required
• Fast print time
• No AMS needed

Assembly

1. Align the round locking tabs inside the votive with the cut-out slots in the base. Press down firmly and twist clockwise to secure.
2. To switch to another votive, twist counterclockwise until you feel a “snap,” then lift straight up.
3. Insert the LED lamp either from the bottom vertically through the cut-out section or;

OR: Trade the cord from above down through the smaller/thicker cut out section:

Align the cord with the arch/cut out section leading outwards and slide the lamp in place.

The LED Tea Light fits in the inner round circle.

If you like this design, please leave a rating, or a comment. If you have a pattern or illustration you’d love to see turned into a tealight, feel free to share your ideas!