Wall Mounted Shoe Holder - Universal Screw or Tape

This is a set of universal wall-mounted shoe holders designed to securely hold a pair of shoes against a wall. The design fits almost any size shoe, boot, slipper, and more, and consists of two parts that snap together: a base plate and a pivoting arm that locks over your shoes.  

There are two sizes available:  The standard size is made for large format printers and should fit most large shoes and boots up to a US Mens 14-ish.  The smaller size will fit on almost any printer and should fit most shoes up to a US Mens 11-ish.

The base plate includes two screw holes on the back, and the border is 16mm wide, matching the width of most 3M Command Strips, so you can choose whichever mounting method you prefer. If you go with screws there is a printable screw template included to get the spacing exact. The plate is also thick enough to rest a level on for a perfect install.

The ends of the arms need support so that is enabled within the print profile just for those.  Any material should work as mine are printed in Bambu Matte PLA and have been holding up just fine. If the holders will be used in a garage or anywhere with significant temperature swings then PETG, ABS, or ASA would be a better choice. Both parts are printed face down so the outward-facing surfaces have the best texture and the back holes don't need support like this, at least for PLA.  If you are printing something where very short bridges my droop you may want to enable supports for the base.

When installing the arms, press directly on the pins while rotating the arm up and down. It's a tight fit going in, but once seated the arm is held securely and rotates freely.