Dratini

Dratini – 28cm Display Model (High Detail, Print-Ready)

A large-scale, highly detailed Dratini model designed specifically for clean FDM printing and impressive display presence.

This is not a small figurine. At 28cm tall, this model is built to stand out as a centerpiece, whether for collectors, display setups, or as a statement print.

Key Features

• True 1:4 large-scale model: ~28 cm final height
• Optimized for FDM printing: clean geometry, no unnecessary complexity
• Balanced detail vs printability: sharp features without making your printer suffer
• Segmented design: manageable parts for standard build plates
• Stable structure: designed to stand securely when assembled

Printing Notes (Read This Before You Print)

• Settings ready to print
• Recommended layer height: 0.12–0.16 mm depending on quality target
• Use supports where needed(mainly under arms/tail transitions)
• Suggested infill: 3-5% (gyroid)
• Walls: 3–4 minimum for strength at this scale
• Adhesion: brim recommended for Smaller sections

This model is designed to print reliably.

Assembly

• Model is split into logical sections for easier printing
• Parts align cleanly for straightforward assembly
• Glue recommended for final bonding

• Who This Is For

• You want a large, impressive Pokémon display piece.
• You care about print success.
• You’re willing to invest print time for a high-impact result

• Important

• This is a large-scale project. Quality is preferred over print time.
• If you print it, share your results.