BBS Desk Tidy

BBS Alloys desk tidy pen holder.

So there are multiple plates in the file but you dont need to print all.

if you have AMS unit:

• Print plate 1 for the base, or plate 6 for the base with no wheel stand (props the separate wheel up)

• Print plate 2 for the wheel all in one.

If you want to have a better surface finish on the colour part of the wheel and dont mind printing in separate parts, print the multipart wheel from plate 3 and the coloured centre from plate 4.

This is printed at an angle resulting in minimal layer lines on the front face, not sure if I'd trust this much on an A1 or Mini though. 

I've test printed it multiple times on my P1S with no bad results yet!

If you dont have an AMS unit:

• As above print plate 1 or 6.

if you want the black rim around the base, put a pause after layer 10.

Start print on black, pause, then change to grey or silver for the rest

• Print plate 3

• Print plate 4 (angled print) or plate 5 (flat print)

Happy Printing!