Coyote Rocket - Wind Spinner

Update

05.05.2026

v 1.1 - I extend the pale a bit

v.1.2 - I reinforced the propeller blades, added a new base,

Overview

The inventor coyote from the cartoon was one of my favorite childhood characters. I loved his creativity and inventions. I decided to pay tribute to him by creating this project. This is my third model in this style. You can find the assembly instructions in my first project, Wizard Broom: https://makerworld.com/pl/models/2660624-wizard-broom-wind-spinner#profileId-2942945

The second project is: “Scout Trooper”
https://makerworld.com/pl/models/2746249-scout-trooper-wind-spinner#profileId-3046131

Below are some differences compared to the previous models:

• In the print profile, you will find two color versions: one with 4 colors and one with 3 colors. You can choose which one to print. Of course, the 3-color version prints faster.
• While printing the rocket, you can disable the prime tower. In the case of the rocket, it is not needed and the print time is reduced by about half an hour. Unfortunately, it cannot be disabled for just one object, so I had to leave it enabled to ensure the coyote prints properly.
• The rocket has a screw-in axle for the propeller.

• The rocket also includes several mounting points for the rod. This is designed so you can balance the entire project.

  

• After assembly, find the balance point so the rocket with the coyote can stand on the rod without tipping over.
• The coyote can be glued in place to prevent it from sliding.

Have Fub :)