Treaslin/VSD N1 Stream Deck Under Desk Tilt Mount

his is an under-desk pull-out and tilt mount for the TreasLin N1 Stream Deck / Stream Controller, also sold in some listings as the VSDinside Stream Dock N1.

The mount is designed to keep the N1 tucked neatly under the front edge of your desk when not in use. When needed, it can be pulled out and tilted down to approximately 45 degrees, giving a much more comfortable viewing and button-pressing angle.

I designed this for my own desk setup to keep the controller accessible without permanently taking up space on the desktop.

USB-C adapter

This mount is designed around a specific right-angle / rear-exit USB-C adapter sold on Amazon UK:

Amazon UK adapter: ASIN B0FJRHJZ11

The adapter allows the USB-C cable to exit directly towards the back of the mount, helping keep the cable tidy and avoiding the cable sticking out awkwardly from the side/front.

Other USB-C adapters may fit, but this model was designed specifically around the adapter linked above, so please check dimensions carefully before printing if using a different one.

Compatibility

Confirmed design target:

TreasLin N1 Stream Deck / Stream Controller

Likely similar or related device:

VSDinside Stream Dock N1

I have not personally confirmed fitment with every rebranded or similar-looking version, so please compare your device carefully before printing. Some devices may look almost identical but have small differences in casing, USB-C port position, or overall dimensions.

Print notes

The included 3MF file has been set up with print settings in mind.

Some parts are intentionally set to print without supports to help achieve a cleaner fit where it matters. Other areas use custom support settings where needed.

I recommend using the supplied 3MF as the starting point rather than simply importing the STL files with default slicer settings.

Assembly notes

Some glue will be required during assembly.

Test fit the moving parts before final assembly. Depending on your printer, filament, and tolerances, you may need to lightly sand or clean up some edges for smooth sliding and tilting.

Files included

The Fusion 360 .f3d file is included for anyone who wants to make their own personal modifications.

Please note: this is for personal use only. The MakerWorld Standard Digital File License applies.

Why I made it

I wanted a cleaner way to mount my second N1 controller under my desk while still keeping it easy to use. The pull-out and tilt-down design makes it much more practical than a fixed flat under-desk tray, especially when using the controller for shortcuts, macros, or CAD workflow controls.