Wall/Cupboard-mounted Bin Bag/Roll Dispenser

Compact wall-mounted dispenser designed to hold and dispense bin bags from a roll. The front cut-out allows easy access and controlled pulling of bags, while keeping the roll neatly contained.

The design supports two mounting methods:

• Screw mounting via four rear slots for a secure, permanent install
• Adhesive mounting using double-sided tape for non-destructive placement

Optimized for standard bin bag rolls and suitable for kitchens, utility rooms, or inside cabinets.

Key Features

• Clean, minimal enclosure with front access slot
• Supports multiple mounting options
• Keeps rolls tidy and prevents unraveling
• Easy reload by dropping in a new roll
• Compact footprint for tight spaces

Print Settings (Recommended)

• Material: PLA (tested with PLA Basic)
• Layer height: 0.2 mm
• Walls: 3–4 perimeters
• Infill: 15–20% (grid or gyroid)
• Supports: Not required
• Orientation: Print upright (as shown)

Dimensions / Fit

• Designed for standard bin bag rolls (adjust scale if needed)
• Ensure roll width and diameter match your local bag type

Mounting Notes

• For screws: use countersunk screws sized to your slots
• For adhesive: clean surface thoroughly before applying tape

Potential Improvements (optional section)

• Add drainage holes if used in damp environments
• Scale width for larger/heavier-duty bag rolls
• Consider PETG if mounting in warmer areas

Remixes Welcome - Please share improvements.