Deli HT4018 Utility Knife Gridfinity (Remix)

Deli HT4018 (18mm size) Utility Knife Gridfinity with the custom brim part removed in it to now be compatible with the "Gridfinity Rebase" (https://gridfinity.tools/rebase/) web app (but this remixed model file hasn't been rebased yet). This remixed model now has the custom brim piece deleted in it, as the only change to the original model. The author had added the custom brim to the model (as an object in the model) to help with adhesion, as it is probably required to have that part in place OR you can make sure to enable the "Brim" setting (of at least 9mm) in your slicer app for this remixed model to be able to adhere to the plate, or to elimate the chance of warping. The custom brim part in the model is not needed, and can (and in this case will) interfere with being able to rebase the model using the "Gridfinity Rebase" (https://gridfinity.tools/rebase/) web app for instance, which can be utilized to easily replace the Gridfinity base with any other GF base, such as one that contains different magnet design (types); that tool automatically finds bases in the STL file you need to print, then cuts them out and replaces them with your preferred base. Both the original model, and this remix model contain the same magnet design (types) which in that case are 4 x total magnet holes on the far left and right bins only (not on all 5 bins), that are the normal round holes. If you want to rebase this remix with that web app you can do so, for instance to have magnet holes in all 5 bins, and in a different magnet style (types) if wanted.

Note: The author of the original model (https://makerworld.com/en/models/2575042-deli-ht4018-utility-knife-gridfinity) stated in chat to me about it: “To answer your comment about the deli knife Gridfinity model, this design has a custom brim to reduce warping. Gridfinity models tend to warp severely, and the brim should detach cleanly from the model after printing.”. Make sure that if you utilize this remix model that you enable the “Brim” setting (of at least 9mm) in your slicer app for this remixed model to be able to adhere to the plate, or to elimate the chance of warping.

The removed built-in to the model custom brim (with the original magnet holes on each opposite side of the model) on this current remix model can be seen in the single screenshot below:

Just for reference, the original non-remix model had a built-in to the model custom brim in it (that should be easy to remove after printing that original model, but it will block being able to rebase it easily) as can be seen (for reference) in the single screenshot below: