hand powered light (with tt motor)

This model serves as a hand-powered flashlight for use in nature, for example. I used a glow-in-the-dark PLA so I could always find it at night.

Transparent filament is also needed to print the translucent top of the light. And I recommend choosing PET-G for printing motor shafts as is the case in the printing profile.

assembly instructions: 

you will need: TT motor

                          super glue

                          2 LEDs of different colors (if like me you want to connect them antiparallel so that the      flashlight lights up in different colors depending on the direction of rotation)

1. Disconnect the USB cable from the motor and solder the LED(s) (if you want you can do it in antiparallel)
2. Place the shaft on the motor and insert it into the housing so that the shaft comes out of the hole
3. Glue the transparent cover to the front of the cover and then the cover lid

4. glue the handle (insert the longer rod into the hole in the oval, then insert the hollow cylinder and secure it on top of the longer rod with a small pin).

   Then place and glue onto the motor shaft

5. 

   Enjoy the flashlight