Search models, users, collections, and posts
Vespa ET4 150 Rear Number Plate Holder AUS
IP Report
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
3.3 h
1 plate
Open in Bambu Studio
Boost
1
2
0
0
4
1
Released
Description
This is a simple number plate holder to fit a Vespa ET4 150 rear mudguarrd and standard NSW plate (same size as VIC, QLD, and TAS also) using the standard mounting holes. It should fit other models as well with the same spacing (80mm) between the bolt holes. The bolt holes are setup for M5 Bolts, and will need to be 12-15mm long to make it through the mount and rear mudguard.
I used dounble sided tape the mount the actual plate, but you can drill through the plate to matchnthe holes in the actual license plate.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)