BLV Riser V4 / Space Pi+ Stability Reinforcement

English

These reinforcements are designed (with Tinkercad) to stabilize the Creality Space Pi Plus holder on the BLV AMS Riser v4, which can be found here :

1. Riser : BLV AMS Riser V4
2. Dryer Holder : Creality Space Pi Plus Holder

Important note : This model requires manual drilling.

1. Print both reinforcements.
2. Position them to mark the hole locations on the holder.
3. Drill the holder (3mm drill bit) and lightly countersink so the screw head is flush.
4. Fasten everything with M3 screws.

Required hardware :

• 4x M3 Screws + 4x M3 Nuts
• Amazon Link (Hardware) : M3 Screws and Nuts Kit

Print Settings

• Filament: Bambu PETG-HF
• Wall loops: 4
• Infill: 25% (Gyroid)
• Supports: Yes / Yes
• Support Interface: PLA if possible with AMS (Highly recommended for a clean finish and easy removal. I tested with PETG and it's very difficult to sand in the curves! But if you're printing this, it's because you have an AMS Riser!)