Search models, users, collections, and posts
3m respirator head harness
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Open in Bambu Studio
Boost
5
7
1
2
15
8
Released
Description
3m respirator head harness
Have used it for a few weeks now.
Mine looks crooked only because I hang it on a nail in my shed.
Used PLA for the harness.
It's been in the shed the entire time. No problems so far.
Will update this when it gets hot out.
It's a bit difficult getting the tabs to snap in place had to use pliers.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)