Search models, users, collections, and posts
Simple Covertec Belt Clip
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
32 min
1 plate
Open in Bambu Studio
Boost
11
27
6
0
44
22
Released
Description
I wanted a simple belt clip to wear in time for May the Fourth. Unfortunately, what could find didn't fit the sabers I had, or were more complex than I wanted to print at the time. So I designed this!
I printed it in the orientation of the file (upright) without the need for supports. You may need to separate the belt clip part with a hobby knife.
It is designed to fit my 30mm/1.1875" wide belt.
I have tested it, and it works with the following sabers:
UnimatrixRed's Qui-Gon Jinn Lightsaber
ceo51378's Obi-Wan Kenobi Episode 1 Lightsaber
CaseStudyno8's Stormtrooper Lightsaber
I'll add to the list as I print and try out more. Apparently, most of my sabers have D-rings!
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (6)