Vertical Stand for Novation LaunchKey MK4

This is a fork/remix of my original vertical stand concept, adapted to store a Novation LaunchKey MK4 upright in a shelf or cabinet. It’s made to save space and keep the controller neatly displayed when not in use, while remaining simple and reliable.

Design notes

• Inner clearance for pads: I left about 1 mm of tolerance inside so you can glue anti-slip/felt/rubber pads (as shown in the photos).
• Pads help with:
  • better grip and stability,
  • reduced vibrations,
  • protection against scratches.

Print recommendations

• No supports required (designed specifically to print cleanly without them).
• Print orientation: print it in the same orientation as it will be used.
• Material: PLA works fine, PETG recommended for extra toughness.

You can fork/remix this design by downloading the Fusion 360 .f3d file available on the base model, and adapting it to your own device.