Zonai Outpost Chest – Zelda TOTK

Zonai Outpost Chest – Zelda TOTK ✨

A high-detail recreation of a Zonai Outpost Chest inspired by The Legend of Zelda: Tears of the Kingdom, designed as a display piece, collectible prop, or game-room decor item.

This model is designed to capture the layered stone-like panels, engraved Zonai-style patterns, raised front detail, and ancient relic look of the in-game chest while still printing cleanly on FDM printers.

Great as a shelf display, Zelda collectible, painted prop, or decorative piece for any gaming setup.

🎨 Perfect For

✅ Zelda fans
✅ Tears of the Kingdom displays
✅ Game-room decor
✅ Painted props
✅ Shelf displays
✅ Collectible prints
✅ Cosplay / prop setups

🔧 Print Notes

✓ Optimized for Bambu CoreXY printers
✓ Tree supports used for underside and hanging/details areas
✓ Print orientation is already set in the profile
✓ 0.12–0.16mm layer height recommended for best results
✓ Matte ash gray PLA is what I used, but no specific filament is required
✓ Slower outer walls can help preserve the engraved panel details
✓ Works great as a display piece, painted prop, or collectible

🧼 Before Printing

Please clean your build plate before starting the print. A dirty or oily plate can cause lifting, warping, or poor bed adhesion, especially with detailed supported prints.

Recommended prep:

✓ Wash the plate with dish soap and warm water, then dry fully
✓ Avoid touching the print surface after cleaning
✓ Use glue stick or liquid glue if your plate normally has adhesion issues
✓ Add a brim if you notice edge lifting or instability
✓ Watch the first layer to make sure it is sticking evenly before walking away

📏 Scaling

Scale up or down depending on your display space, print time, and detail preference.

If scaling smaller, some of the engraved patterns and smaller raised details may become less visible. For the cleanest result, I recommend keeping the model at the uploaded size or scaling up slightly.

⚠️ A1 / A1 Mini Note

This profile was tuned on CoreXY printers. It should still print well on A1 / A1 Mini, but slowing speeds slightly and using a brim can help with stability.

A dedicated A1 / A1 Mini profile may be added later.

🟢 More Zelda Prints

If you like this print, check out my other Zelda props and collectibles below:

Zelda Props & Collectibles Collection (Click the image): 

I’ll be adding more Zelda-inspired props, Elden Ring models, cosplay accessories, anime-related prints, and collectible display pieces regularly.

If that sounds like your kind of stuff, a follow would help a ton and you’ll see new models as they go live 🙌

If you print this, I’d really love to see how it turns out. Feel free to share your photos, painted versions, or display setups 👀