Donkey Kong DK multi-part print, can be used as a single pen holder (no AMS required)

I hope my works can bring happiness to everyone! However, as a designer, I am merely a messenger who turns ideas into reality and cannot fully understand everyone's needs. If you have any good model ideas or requirements, please leave me a message. I will do my best to create works that meet your expectations!If there could be a boost, that would be even better!

Game Character collection (Includes all classic game characters I have made)
China region entrance

International region entrance

Donkey Kong is a Nintendo character who first appeared in the 1981 arcade game Donkey Kong. He is an eight-hundred-pound muscular gorilla. Starting with the 1994 remake of the handheld version of Donkey Kong, he wears a red tie with his initials 'DK'. Donkey Kong has always appeared as a protagonist in the new millennium, but in the Mario vs Donkey Kong series, Donkey Kong has exhibited 'retro' behavior by kidnapping Pauline. However, Donkey Kong has always been seen as acting out of jealousy or anger rather than being a true villain, and Nintendo has repeatedly depicted friendly interactions between Donkey Kong and Pauline in subsequent games in the series.

The standard size is 20CM. If you need a size not available in the print profile, please scale and print based on this version!

Body
Dark brown or reddish brown
Belly face Light brown or skin tone
The face is small, and the highlight part of the eyeballs is not separated, please color it yourself with a marker pen!

The model has no flaws. The chest marks are due to my filament quality issues, please forgive me! I don't have other similar colored filaments to re-print.

Note: Install the two tie parts first, other parts are easy to install.
The DK logo can be painted by yourself without printing, the tie retains the marks
This model is not symmetrical. Please distinguish between left and right for all parts.
When removing supports, be careful not to break the flaky hair!

The following are instructions and precautions:
 Apologies, because I did not want to compromise the integrity of Donkey Kong's body, the model body was not split, which means a perfect bottom surface cannot be achieved. Unlike previous models, this model will generate a small amount of supports. I have tried my best to hide the support surfaces in invisible areas during plating. If the support surface doesn't look good, you can try removing and trimming it. I usually use a lighter to gently spray the burrs on the support removal surface (proceed with caution).

Some parts require super glue for assembly!

5.26 Update reminder
My sincere apologies. A 28CM print profile was previously added with incorrect head proportions. It has been fixed and uploaded. Friends who have printed parts, please re-download and confirm re-printing the head of version 1.2

(For 3D printing learning purposes only, not for commercial use)

Update log

5.4 Added an optional banana held in hand, at the request of players, optional print profile, download the corresponding version if needed

4.30 Thanks to group member Chen Jie for his suggestions and feedback!
Version 1.1 adds a hand in a gripping pose, which can be used as a pen holder for a desktop ornament, test results are as shown.
20CM version gripping hand, minimum hole diameter approximately 12MM 
The 15CM version gripping hand has a 10MM diameter negative part inside, please adjust the size and angle yourself according to the item you want to insert (pen or other)

I hope my works can bring happiness to everyone! However, as a designer, I am merely a messenger who turns ideas into reality and cannot fully understand everyone's needs. If you have any good model ideas or requirements, please leave me a message. I will do my best to create works that meet your expectations!If there could be a boost, that would be even better!