B-17 bomber-T class

Catalog => <Warship-Ship>-<Fighter-Aircraft>-<Vehicle-Tank>-<Aerospace>-<Miniature>-<Mecha>-<Weapon>-<Uncategorized>

B-17 Bomber - T Class

This is a highly detailed model, optimized for easy 3D printing. It has been specifically designed for 3D printing

More imagination was incorporated and it is not identical to the original

Multiple parts of the entire model are movable, the landing gear can be retracted, and the top cover can be removed to reveal the interior

Printing Tips:
Printing plate: Use a textured PEI plate
Filament: Bambu Lab PLA
Layer height: 0.12 mm
Outer wall count: 2
Acceleration: Set all accelerations to 1000 mm/s² or lower
Important Notes:
Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.
Before printing, thoroughly clean the PEI printing plate to ensure good adhesion, and ensure your filament is dry.
Special thanks to all friends for your attention, likes, downloads, and support!

============================================================================

Single cockpit, movable wings and canopy, glue required for assembly.

placed and taken out.

Printing Tips:

Print Bed: Use a textured PEI sheet.

Material: PLA

Layer Height: 0.12mm

Outer Wall Count: 2

Acceleration: Set all acceleration values to 1000 mm/s² or lower.

Important Notes:

Some sanding and gluing may be required due to material shrinkage and printing tolerances. Apply even pressure when assembling parts.

Before printing, thoroughly clean the PEI print bed to ensure good adhesion, and ensure your material is dry.

Special thanks to all friends for your attention, likes, downloads, and support!