Search models, users, collections, and posts
Print Profile(5)
Single - 0.2mm layer, 5 walls, 55% infill - PETG
Designer
1.5 h
1 plate
2 x screw - 0.2mm layer, 5 walls, 55% infill
Designer
2 h
1 plate
4 x screw - 0.2mm layer, 5 walls, 55% infill
Designer
3.3 h
1 plate
6 x screw - 0.2mm layer, 5 walls, 55% infill
Designer
4.8 h
1 plate
Click to see more
Open in Bambu Studio
Boost
52
190
9
5
109
72
Released
Bill of Materials
Bambu Filaments
Select all
Description
Simple ground screw designed as a replacement for robot mower charging station anchors, but works just as well for general garden use (tarps, borders, small fixtures, etc.).
Length: 150 mm
Drive: Hex head (~8 mm across flats, fits Allen key)
Print recommendations (tested):
- Material: PETG
- Layer height: 0.2 mm
- Walls: 5+
- Infill: 50% or higher
- Tilted orientation helps improve strength
Notes:
- Don’t force it into very hard/dry soil (pre-loosen ground if needed)
- Designed for grip, not brute force installation
Works as a solid reusable alternative to plastic ground stakes.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (9)