Gary – X-Axis Stop Spacer for ZT610 / 110Xi4

“Gary” is a small but practical spacer designed to extend or replace the original X-axis media stop on industrial label printers.

This model was primarily designed for the ZT610, allowing the user to extend the original X stop and properly align narrower labels that would otherwise not be supported by the stock guide.

Additionally, it also works as a replacement stop for the 110Xi4, thanks to the integrated mounting hole that allows it to be secured directly onto the original rail using a screw.

Despite its simple design, it solves a very specific (and annoying) limitation when working with smaller media widths.

And yes… it looks like a tiny snail 🐌 — that’s why it’s called Gary.

🔧 Installation

ZT610

• Slide the X-axis stop all the way to the right
• Gently place Gary with the “teeth” facing downward and the “fin” aligned into the left rail
• Move the X-axis stop back into position according to your label width

110Xi4

• Align the “fin” with the rail where the original stop was installed
• Secure Gary using a screw that fits the rail slot
• Adjust Gary as needed based on the label width