Eye clicker fidget keychain Ace Ventura style

Fast print times: 

Human eye around 50 min 
Animal eye around 60 min

Now everything can have clicky eyes, in Ace Ventura style

Don't be afraid to push it, it wont hurt :)

There are 2 profiles:

1.  With keychain (choose the build plate you need - human eye, animal eye, human pair, animal pair)
2.  Without keychain  (choose the build plate you need - human eye, animal eye, human pair, animal pair)

All print plates print by object

There is high tolerance on the socket where the keyboard switch goes inside, it needs to be pushed hard it. 

Printer must be calibrated with good tolerances, and please do flow dynamics calibration before print.  And do not forget to clean print bed with soapy water now and then. 

1. remove the supports of the socket

   

2. Get your keyboard switch

   

3. Remove or bend the contacts (BE AWARE THAT IF YOU CUT THEM THEY FLY, PROTECT YOUR EYES)

   

4. Connect the eye with the switch, if it does not go it, rotate the switch and try again, tolerances are tight, but I did not have problems to connect.

   

5. Pop it inside the socket till you hear *CLICK*

   

6. You can always disassemble it, pushing to the white pin from the bottom.

If it gets stuck when clicking, disassemble it and assemble it again, or give the eye a slight wiggle. 

Now GO, put the eyes on everything!