Ninja Turtle Shell Coasters + Magnets

Hey All,

Here is set #3 of my Ninja Turtles coasters + magnets. These use only 4 colors each, and the colors can be adjusted by individual part.

Pack 1 (Turtles and Splinter portraits Coasters + Magnets) can be found here: https://makerworld.com/en/models/2671686-ninja-turtles-coasters-magnets#profileId-2957173

Pack 2 (OG Ninja Turtles Coasters + Magnets) can be found here: https://makerworld.com/en/models/2680408-og-ninja-turtles-magnets-coasters#profileId-2968422

My coaster container will fit the pizza coaster in this set and (fits all of my round coasters and ANY standard size 4 in / 102 mm round coaster) (multiple size options) can be found here: https://makerworld.com/en/models/1898470-coaster-table-container-fits-4in-102mm-coasters#profileId-2034260

They can also all be scaled as needed, but the coasters are set as close to the standard coaster size of as close to (4 in / 102 mm) as I could get.

The magnets (magnet profile) hold three 10x3mm magnets and the pause for those is already inserted for easy pause, insert, and resume. The negative cylinders in objects can be adjusted to change the magnet size if desired (just remember to move the pause as needed). 

Both magnets and coasters in this set have an embossed version with the ironing is turned on for an extra smooth look, and a flat version that prints face down on the plate getting whatever plate texture you need.

**Disclaimer:**  
Fan art by **Rakenra** — shared for **personal, non-commercial use only.**  
Not affiliated with or endorsed by any studios or IP owners.  
Users must comply with copyright and trademark laws.

I will attach the materials and colors I used below.