Buugeng S - STAFF 85cm
Print Profile(1)
Description
Boost Me (for free)
to support the work , Thank you very much!
Membership
The support of a coffee is very little but from many can be truly encouraging and helpful. Thank you!
LINK BUYMEACOFFEE: buymeacoffee.com/mentalist3d
Buugeng 85 cm, can be assembled in 4 pieces
The two S-shaped parts can be closed
The handle is designed to be covered in leather or other material
2 central pieces with snap-fit joints. 2 "S" shaped pieces with snap-fit joints (printed 2 times)
1 round piece to be glued to the end of the "S" following the corresponding joint (see photo) (printed 2 times)
1 2.5 mm locking screw (printed 2 times)
Assembly: Glue the two ends of the "S"
Glue the two round pieces to the base of the 2 newly joined pieces (see photo). Verify the exact alignment of the 2 central pieces before gluing them
Once the correct alignment is confirmed, insert the two round pieces into the corresponding section (see photo)
Use the two printed screws (if using ABS), otherwise replace them with 2 2.5 mm metal screws
( SHARE PHOTOS OF YOUR BUUGENG OR SOME GIFs WHILE BEING EXPERTLY HANDLED AND THE BEST ONES WILL BE USED AS PHOTOS IN THIS PROJECT (if you agree), THANKS AGAIN!! )
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (5)