Sheet music_pen holder

<Product Description>
・This product is a pen holder.

・The motif is based o sheet music.

・Product size (w×d×h）：63mm × 63mm × 123mm

<Production＞
・This product was created using Blender.
・Output was done using BambuLab A1 mini.
 

<Notes> 
・Please use the product appropriately for its intended use.
・Please be careful when handling this product, as it has a sharp tip. Especially, please keep out of reach of children.

・Because the parts are thin and delicate, please exercise extreme caution when removing the support material.
・Please note that we will not be responsible for any accidents or injuries caused by this product.

・We will not be responsible for any damage to a table, etc. caused by the use of this product.
・The photo is for illustrative purposes only.

・When importing into the slicer software, You get the message “Do you want to repair the model? If the model cannot be successfully printed after repairing the model, print the model without repairing it.
・Please note that the product is still in its infancy as a product designer, and that there may be imperfections.
・Please print and use this product only if you agree to the above precautions.

 

We would be very grateful if you could send us your comments and evaluations, which will encourage us to create this product.
Thank you very much.