Link Action Figure (Fully Articulated)

I wanted to give myself a challenge--so I made a fully articulated figure.

I decided to go with Link from Twilight Princess because I like Zelda stuff. When printing, please use the .3mf because there's a lot of valuable settings in there that would ruin the model if you didn't use them.

Some of them are noted here:

The scabbard is not actually hollow. Therefore you must print with 0% infill, 3 walls, and 0 bottom layers for it to print correctly. A lot of the pieces have painted supports for ease of printing, so again, USE THE .3MF! IF YOU DID NOT USE THE .3MF AND GIVE A LOW REVIEW FOR A BAD PRINT, THAT IS 100% YOUR FAULT, MISTER!

The instructions are quite clear, so make sure to download that. The figure itself is jointed as much as possible. I'm brand new to making these kinds of figures, so bear with me, because there might be some problems. If you print it and come across an error or would like me to fix something, please take the time to DM so I can make a better model. Thanks.

A note on the hands/joints:

I used Dummy 13 hands straight from Printables. I scaled them up to 125%-130%, and they work fine like that. In the .3mf they are scaled to 130% so they may be a little on the loose side.

For the joints, just like a regular D13, please print those in PETG. All the PETG parts are grouped together on one plate and they are marked white in the instructions.

Overall, I had a great time making this and I'm proud to present this to the community. I hope you have fun with it too!

Happy printing. . . 

P.S. here's a link to my new V2 model: https://makerworld.com/en/models/2885034-totk-link-figure-v2-fully-articulated#profileId-3222602

Please support me by liking, following, boosting, and/or collecting. Thank you for your help and support!