Search models, users, collections, and posts
SNES Controller Bic Lighter Case
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Open in Bambu Studio
Boost
433
1146
3
2
111
57
Released
Description
SNES Controller Bic Lighter Case. Fits my standard Bic lighter great although lighter sizes my vary. Lighter can be pushed out from bottom hole if too tight to pull out by hand. Lighters with a sticker or graphic wrap might not fit.
There is a pause at 127 to swap out the dark grey for purple to finish.
Do not use supports.
In order to print this on its side without auto supports there are 3 vertical posts that support top while printing and some filament that as it spans the inside top of the lighter slot sags a bit and will have to be removed. The posts can be pulled out quite easy with pliers. I recommend using one side of a pair of scissors to scrape any other loose debris.
Boost Me (for free)
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (3)