Octagonal Shaft Clamp SW60 – 2 pieces

Split clamp for octagonal shaft SW60 – PETG – M5

Clamp designed for **SW60 / 60 mm** octagonal roller shutter shaft, intended to hold drums, pulleys, spacers or other elements mounted on the shaft in position

The design is divided into **two halves**, so it can be installed directly onto the shaft without disassembling the entire setup Both parts are joined using **M5 screws** and M5 nuts, achieving a firm and compact hold

Features

• Compatible with **SW60 / 60 mm** octagonal shaft
• Split design in **2 pieces**
• Joined with **M5 screws**
• Prepared for M5 nuts
• Approximate width: **25 mm**
• Interior adapted to octagonal shaft
• Designed for functional printing in **PETG**
• Useful as a positioning collar, stop or spacer

Recommended use

This part is intended as a **positioning clamp** to prevent lateral movement of drums, pulleys or accessories installed on an octagonal roller shutter shaft

It is not designed as a primary load-bearing element or as a structural safety part

Printing configuration used

• Nozzle: **0.6 mm**
• Profile: **0.30 mm Standard @BBL X1C 0.6 nozzle**
• Material: **PETG**
• Layer height: **0.30 mm**
• Recommended infill: **40–60%**
• Recommended walls: **4 or more**
• Supports: according to print orientation
• Recommended orientation: with the flat base resting on the bed

Required hardware

• Screws **M5**
• Nuts **M5**

Note

Always check the actual measurements of your shaft before printing, as there may be small variations depending on the manufacturer of the octagonal shaft