Odin 2 Retroid Pocket 5 Thumb Sticks

I lost the thumb stick to my Odin 2 and didn't want to pay $10-$30 on etsy to buy a set so I designed my own and they worked out great.
My sticks are 2mm taller than the original to give you a little extra control and for the taller ones they are 5mm taller than the original.
I put a short one on the left for movement and a taller one on the right for aiming.
I made a concave version and a convex version, I based them off the xbox elite caps so they are bigger around than the stock thumb sticks making them more comfortable.
They are friction fit, do not use glue, if too tight increase the size a smidge in your slicer, if too loose decrease the size a smidge, on my X1 Carbon they are just right and a bit tight to get on but once started the slide right on.
I ended up having to use a raft to print these and not have them come off the print bed on my X1 Carbon, even with a brim when it is about 3/4 the way through then end up popping loose from the bed but the raft worked a treat.
No support needed but at least a brim recommended, supports aren't a bad idea though, the tops move around when the plastic is warm.