Tyranid Dominatrix
Print Profile(3)
Description
Another Tyranid model, in this case, the Dominatrix. This model is designed for display as it doesn't have a base, but it's easily adaptable to a generic base
- I have divided the model to facilitate printing and minimize support material usage, so it requires some superglue for assembly. I recommend pressing the halves firmly against each other during drying to prevent a noticeable gap between them (I also used superglue accelerator)
- I have attached 2 print profiles: the first with the maximum size to print everything on a single A1 plate (100%), and another with the maximum size that one half fits on the A1 plate (125%, requiring 2 plates in total)
- Added a third print profile with the “real” size (no official GW figure exists): 25cm height, 45cm length. Divided into 4 parts
The photos are of the 125% profile printed in eSun gray PLA, without any failures or breakages. The result is very good
I hope you like it :) Regards
If you want to check out my other Tyranid models (before they get taken down again) go to my profile or here https://makerworld.com/collections/27666936
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (10)