2025/2026 Ioniq 5 Rear License Plate Adapter

This is an adapter for the rear license plate of the 2025 and 2026 Ioniq 5. I was unhappy with how the license plate doesn't line up with the panel it screws into (vertically). This shifts the license plate up a bit to line up with it, with just a tiny bit being behind the rear camera.

Requirements:
You'll need two 1/4" by 1/2" screws (1/4" diameter, 1/2" length of the threaded part, not including the screw head), and matching nuts. Set a pause at layer 53 in order to put the nuts in, then resume, and the nuts will be embedded into the part. Use the screws that came with the car to screw the adapter in, then use the 1/4" screws to attach the license plate to the adapter.

The build plate on my P1S is not big enough to print this in one go, so it's split into left/right. I used PETG for extra heat resistance.

I've also included an STL file of the model as a single part, in case you have an extra large build plate.