Project Hail Mary Bookmark Set

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

Amaze! Amaze! Amaze! 🚀I think Rocky would approve of the craftsmanship (and the fist bumps). What’s your favorite Rocky quote?

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Blue Transmission Distance: 4

PLA BambuLab Basic Gold Transmission Distance: 5

This print uses 3 unique filaments

Swap Instructions:

Start with Black

At layer #10 (0.88mm) swap to Blue

At layer #11 (0.96mm) swap to Black

At layer #12 (1.04mm) swap to Gold for the rest.

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print.

Stringing may occur with Hueforge, just use a lighter to whisk them away. 

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections