Search models, users, collections, and posts
BMW K1300GT 18mm side stand riser
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
0
2
0
0
3
0
Released
Description
Sidestand riser for a BMW K1300GT. It is printed in TPU for AMS, tough but still a bit flexible. This specific model rises 18mm, and even though it is printed in tpu, it is a tight fit. So it might require a small tap from a hammer to slide on. I have printed with 30% infill, and it is not flexing under the weight from the bike. Please write if you have suggestions to the model.
If you like the model please give a thumps up or perhaps even a boost :-)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)