Surfing dog meme - NO AMS

This 3D model was created with the help of AI 🤖.

I separated the dog into parts: nose, paws, ears, and tongue.

The print consists of 3 main pieces: the dog, the surfboard, and the sea wave

About the dog

This print is based on a TikTok meme: a pitbull ("pibble") dancing while surfing, surrounded by dolphins and rainbows, with the catchy song "Just The Way You Are" by Milky (2002) playing in the background.

Print info

For convenience with this kind of model (especially with thin legs), I like to use magnets so the character can be detached from the base while still holding its pose.

This design uses a total of 4 magnets (6×6×3 mm),  2 in the dog and 2 in the surfboard. 

I usually set the tolerances to 6.15 × 6.15 × 3.1 mm.

If you don’t have magnets, you could try replacing them with a 6×6×6 cylinder, although I’m not sure how sturdy that would be.

I also included versions of the dog and surfboard without the magnet cutouts (i.e., no circular holes), in case you want to modify or customize anything.

I forgot to mention, I almost always rotate the parts before printing. For example, the wave is rotated to avoid supports, but since it's not very visible, you can also print it flat so the base comes out completely smooth.

General Printing Information

Tested on a Bambu Lab P1S

Check out my other models!