Search models, users, collections, and posts
Nerf OBX Ontos Remix - Ontos but XM8
Remixed by
IP Report
Print Profile(1)
0.16mm layer, 4 walls, 15% infill
Designer
40 h
11 plates
Open in Bambu Studio
Boost
43
76
9
16
97
19
Released
Description
The OBX is a remix of the Ontos inspired by the XM8
OBX stands for Ontos But XM8!
This remix is based off the ontos that uses 1.5in/38mm OD tubing and o-rings. NOT THE LEGACY ONTOS
You will require:
a couple more m3x12mm and m3 nuts
2x m3x10mm screws for the picatinny rail
Notes:
There is an experimental grip i have included in the files with a 0.4mm cut indented for you to add textures in bumpmesh.com as seen in the last picture
If you struggle with inserting any of the nuts, i recommend heating them before inserting, depending on the tolerance of your prints, results might vary.
Please leave a comment if you have any feedback
Boost Me (for free)
If you enjoyed these files, you can support me by boosting my model :)
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (9)