Search models, users, collections, and posts
Rocky Project Hail Mary (one piece, supported)
Remixed by
IP Report
Print Profile(2)
0.12mm layer, 4 walls, 15% infill
Designer
6.3 h
1 plate
less support with distance 0.2mm layer, 4 walls, 15% infill
1 h
1 plate
Open in Bambu Studio
Boost
89
246
17
7
620
372
Released
Description
This is the official rocky model from projecthailmary.com, but modified to allow successful printing as one piece. Added a massive brim to keep bed adhesion and changed support parameters to prevent mid-print failures. I successfully printed on a P1S with ABS so let me know if this works on your setups or not. This is a tricky little guy to get printed and I've seen a lot of great workarounds in the community, so check those out if not this one.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (17)