Feline Sakura Bliss

Thank you for downloading my works. If you would like to sell my designs, past and future, a commercial license can be obtained from my MakerWorld or Patreon page.

A tiny piece of spring for your current read. 🐈🌸Sometimes the best part of a story is the moment you pause to look at where you left off - an ethereal, Sakura-themed bookmark featuring a little feline friend enjoying the spring breeze. I wanted this piece to feel like a quiet garden tucked inside your favorite book. Which book do you think needs this view?

Pictures shown are printed in an 0.2mm Nozzle
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Orange Transmission Distance: 7

PLA BambuLab Basic Hot Pink Transmission Distance: 3.9

PLA BambuLab Matte Ivory White Transmission Distance: 3.5

This print uses 4 unique filaments

Swap Instructions:

Start with Black

At layer (0.72mm) swap to Orange

At layer (0.88mm) swap to Hot Pink

At layer (1.2mm) swap to Ivory White for the rest.

Can be resized to accommodate your printer or preference by adjusting the X and Y axis the same percentage while leaving the Z axis at 100%. The best way to achieve this: With Uniform Scale checked, adjust the Y axis to the desired size (this will ensure the X axis is the same proportion as the Y axis), uncheck the Uniform scale, adjust the Z axis back to 100%, slice plate, and print.

Stringing may occur with Hueforge, just use a lighter to whisk them away. 

More prints: Bookmarks -- Portraits -- Coasters -- Clocks -- Puzzles -- Display Stands -- Display Frames

They are sorted and can be found in my Collections - https://makerworld.com/en/@3djd/collections