Out of the Frame – Canine Rampage

Out of the Frame – Canine Rampage🐶🐕

Part of the Out of the Frame collection, a savage pack of snarling canines explodes through the frame in a storm of fangs and fury! This high-detail wall piece features an integrated keyhole on the back for easy hanging. Raw primal energy that breaks every boundary.

Print profile

• Layer height: 0.12-0.16 mm
• Walls: 2
• Infill: 5% Gyroid (infill combination enabled)
• Supports: Tree(auto)

  • Don't forget to remove supports underneath the chin

    

Plates

1. 100mm 0.12 layer
2. 150mm 0.16 layer
3. 100mm 0.16 layer fuzzy skin (point distance 0.2, thickness 0.1)

Key Printing Tips:

• Disable “Strength → Detect Thin Wall” → gives smoother, cleaner surfaces on detailed parts.
• Always check the slicing preview in Bambu Studio before starting the print.
• Support removal trick: Cut supports into small chunks first, then gently loosen → they usually pop off cleanly without damage.
• Some plates use lots of supports, if so → for reliable prints use these filament settings:
  • Filament Overrides
    • Z Hop When Retract: 0.6 mm
    • Z Hop Type: Spiral
    • Travel Distance Threshold: 1 mm
    • ✅ Enable Retract When Changing Layer
  • Also, disable these settings in Bambu Studio if Variable Layer height is used:
    • Supports
      • ❌ Disable Independent Support Layer Height
    • Others
      • ❌ Disable Reduce Infill Retraction
    • I’ve found that a 0.15 mm top Z distance works best when printing with variable layer height.

Happy printing! Can't wait to see photos of your prints! If you're scaling, experimenting or encounter any issues, let me know → your input helps the next iteration. Please share your feedback for any rating below ⭐⭐⭐⭐⭐ so we can work on improving, thank you!