Spill & Refill Coffee Mug Fidget

Spill & Refill Coffee Mug Fidget - all the fun and none of the mess ☕️ 🙌🏼

Instructions for 3D Printing the Twisty Coffee Insert piece:

PLA or PETG work great

0.2mm Layer Height

Outer Wall Width 0.6mm

Inner Wall Width 0.6mm

X-Y Hole Compensation 0.05 mm

Elephant Foot Compensation 0.15 mm

Arachne Wall Generator turned ‘on’

0% Infill 

Outer Wall Speed 50 mm/s

Inner Wall Speed 100 mm/s

Instructions for 3D Printing the Coffee Mug:

PLA or PETG works great

0.2mm Layer Height

15% Infill for the coffee mug

Supports needed on mug handle

I have included a 3mg Print Project with the following settings:

Print Plate #1 (Twisty Coffee insert): 1 color, Outer wall & Inner wall Width 0.6mm, X-Y Hole Compensation 0.05mm, Elephant Foot Compensation 0.15mm, Arachne Wall Generator ‘on’, 0% Infill, Outer Wall speed 50mm/s & Inner Wall Speed 100mm/s (modifier added to screw section of coffee insert to increase the infill in that area)

Print Plate #2 (Coffee mug): 1 color, 15% infill, Outer Wall speed 50mm/s & Inner Wall Speed 100mm/s

Assembly: Screw the twisty coffee insert piece into the coffee mug making sure not to over tighten it (if you overtighten it, it may not “drop” as smooth or might end up pulled ‘tighter’ to one side of the mug).

My designs are free for personal and non-commercial use. I offer a commercial license on Thangs. Here is a link if you'd like to check it out 👉 https://thangs.com/designer/3DPmom

If you like my work and want to help support it, you can buy me a Diet Coke at https://www.buymeacoffee.com/3dpmom Thanks so much!

Have fun printing! 

Erin