Tap to Pay Customizable Credit Card Square Wand

A tap to pay customizable square wand.  Use with your chip enabled credit card.

Two Versions:

With Slots: You can edit the square to add text.  See pictures for where in Bambu Studio to click to do so and what settings. It's currently set to “GO AWAY”
No Slots: You can just glue things to this one but make sure you don't glue things that are thick or it won't read on the CC readers

Multiwand Compatible:
The parts of this wand can be interchanged with the parts of other wands I have designed that are also listed as multiwand compatible.

Assembly Instructions:
1. Allow the cards to cool before removing from printer. Removing when warm/hot may make them not lay flat

2. Remove all support material, including under the tabs of the card(s)

3. Hold the part that the CC holder in front of you with the opening to your left or right

4. Place a card with the tabs closer to you into the slots of the holder

5. Slide your thumbs from the closer side of the card to the far side to arch the card and allow the tabs to click into the other side

6. Repeat for the other side (if it's a two card wand design)

7. Hold the credit card holder with the opening facing up then slide your card in
8. If the design has a spacer, slide that in after your card

9. Screw the extension onto the assembly

10. Screw the grip into the bottom of the extension

11. Enjoy

Warning: Please note, if you print this with silk/shiny filament it's more likely to break.  Please also note this is 3D printed and printed thin to enable the chip to work, you do need to be somewhat careful with it or it will break.

See all my Tap-to-Pay designs here https://makerworld.com/en/collections/20623205-tap-to-pay-designs

Pictures: I love seeing pictures of your final prints from my design (genuinely).  If you are doing cake pops I love seeing the final cake pops also!

Design requests: If you have a design request feel free to send me a message regarding it and if it's something I can do I will give it a try!

Ratings: If you rate less than a 5 star rating please provide detailed reason as to what the issue is and pictures if possible.  I'm always looking to improve designs but can't do so without feedback.  Please make sure the issue isn't related to your specific setup/filament and keep in mind silk filament tends to be weak.

Please boost!! Boosting my designs helps me fund my hobby and keeps the designs coming!  Thank you to all that provide boosts!

Selling: If you would like to sell prints of my designs please please subscribe to my membership.  I think I have the memberships priced affordably for most people and the funds help me continue my hobby and cover filament/maintenance.  Thank you for those who subscribe and don't steal the designs.