Mechanical Batman Height 33cm (no AMS) Bat Man

• Model height 33cm
• This model is printed in multiple parts, no AMS required
• Supports and printing arrangement have been optimized with no obvious support defects, the actual result is very good
• It is recommended to use a layer height below 0.12 for printing

Important, important, important: First install the face, then install other accessories. When installing other accessories, there might be fitting issues sometimes, just push it in with a little force

Assembly diagram is as follows

The IP copyright of this model belongs to  DC Comics,commercial use is prohibited

Work declaration: The creation of this model is intended for learning and sharing 3D modeling technology. This model is created for non-commercial use. I will not engage in any commercial activities with this model, nor will I authorize any downloaders to use it for commercial purposes, including but not limited to selling, renting, or creating derivative works for commercial use. If this model involves any copyright infringement, I will delete it immediately. Downloading and using this model signifies your agreement to comply with the above terms. If you have any questions or disputes, please contact me directly. Thank you!