Nightforce NXS Scope and Mount for MILITECH guns

Nightforce NXS Scope and Mount for MILITECH weapons. This is a scaled model so some parts get thin but I have reinforced those parts and made some slight changes. If you do not like or want to use my mount, this scope can be glued into the scope mounts MILITECH has already designed. Like most of my attachment models, I have added a adjustment tab inside the rail claw on the mount. sand, file or cut this down until it slides onto your picatinny on your MILITECH guns. 

Printing:

Due to the thin walls I recommend printing all parts at 100%. Unless I specify below, assume no supports for the parts I do list.

Scope Body- Supports from build plate only

Scope Mount main body- All supports. Be careful removing supports. I recommend using forceps or needle nose plyers to grab and pop the supports out. Often on small prints of any kind, snips will separate the layers and split the entire print in half.

Assembly:

If you look at the picture, it is pretty easy to piece together. All the parts will need to be super glued accept the sunshade. It should stay on by friction so do not chamfer it without test fitting. There are two scope ring options for the mount. The rails on the one set of scope rings should accept other MILITECH picatinny accessories like laser range finders and micro red dots that I plan releasing in the future.