Search models, users, collections, and posts
GI JOE USS Flagg Elevator Base Support Beam
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
38 min
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
38 min
1 plate
Open in Bambu Studio
Boost
1
8
0
0
3
1
Released
Description
A common lost part of the USS Flagg structure, the elevator base support connects the sides of the elevator structure, for some horizontal stability. Couldn't find an existing design, so I created my own. Prints in two parts to fit on most plates, then connects snugly via a tab in the middle. Cutouts on the ends to fit into the original beam location.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)