Detachable Car Sun Visor Tissue Mount (PIP)

 🛑 Selling prints is not allowed - but with the right license, it can be.

💛 Join my membership below to start making money. 

There are main reason I went for a detachable design is because if the mount part breaks or gets damanged, you just print another one instead of printing the whole thing with the tissue box itself wasting a lot of unneccessary filament. 

I was also getting tried of my tissue box getting crushed in the backseat or taking up valuable cup holder space. This design mounts a standard slim tissue pack directly to your car sun visor for easy access while driving. The two part design uses a sturdy clip that slides securely over the visor keeping the dispenser from rattling or dropping when you hit a bump on the road. It clears up interior clutter and keeps your napkins right where you actually need them without blocking your view out the windshield.

Since car interiors get extremely hot during the summer PLA is definitely not recommended for this project. You will want to use PETG ABS or ASA so the visor clip does not warp or lose its tension under the heat of the sun. The tolerances on the clip attachment are designed to be snug so it stays firmly in place once assembled but you might need to apply a little pressure to snap it together depending on your printer calibration.

If your tissue box is slim enough you can fit it, else you can add tissue manually to the issue box.

---------------

See My Latest 3D Models in Action! 🚀 

behind-the-scenes building, printing timelapses, and new models.

🔴 Watch on YouTube 

📸 Follow on Instagram 

🎵 Catch me on TikTok