Ninkear N10-N10 Pro Wall Mount

🖥️ Ninkear N10 / N10 Pro Wall Mount

Clean and minimal wall mount designed specifically for the Ninkear N10 and N10 Pro mini PCs. Keeps your setup tidy while allowing full access to all ports.

✅ Features

• Compatible with both Ninkear N10 and N10 Pro.
• Bottom gap allows easy cable access (USB, HDMI, power) without obstruction.
• Hexagonal ventilation pattern on the base for passive airflow.
• Mounted with 2 round-head screws and 2 wall anchors.
• Clean, low-profile design that sits flush against the wall.

⚠️ Before installing Remove the 4 rubber feet from the bottom of the mini PC so it slides smoothly into the mount.

🔩 Hardware needed

• 2× wall anchors 6 mm
• 2× round-head screws ~3.5 mm × 30 mm (heads must not protrude to allow PC removal)

🖨️ Print settings

• Material: PETG recommended (better heat resistance and rigidity than PLA, though PLA works fine in cool environments)
• Layer height: 0.20 mm (Strength profile recommended)
• Infill: 25% (15–20% minimum acceptable)
• Infill pattern: Gyroid
• Top surface pattern: Concentric
• Walls: 4
• Supports: Required — tree supports on the top lip/flange only. Not needed on the hexagonal area.

📝 Notes

• Supports were placed manually in the original file. If they don't appear in your slicer, add tree supports only on the top overhanging edge.
• Printed in PETG-CF at reduced speeds. If using standard PETG or PLA, default speeds work fine.
• The 3mf profile included is optimized for Bambu Lab printers. STL file included for other slicers.