Search models, users, collections, and posts
KJW KP-08 Holster
IP Report
Print Profile(1)
0.2mm layer, 5 walls, 25% infill
4.9 h
1 plate
Open in Bambu Studio
Boost
28
62
2
2
98
14
Released
Description
As there is no commercially available holster for the KJW KP-08 i just designed this one off of an 1911 holster.
The holes for the pin in the release and the main body may still need a small drill, for whatever pin-size you're using.
For the spring located under the release i used a small diameter leg spring, strong enough to hold the pistol in place.
I advice gluing in hex nuts in the hexagonal spaces in the main body for mountin to the mountin-plate.
Notes:
- Print with as much outlines as possible (for maximum durability)
Category: Sport & Outdoors
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (2)