Resin Curing Wash Bucket Alternative Turntable

Suitable for sealed buckets with a 12CM wide bottom

Suitable for magnetic stir bases

Please note Before printing, please measure the size of the magnets in the old bucket or magnetic base It should not differ too much from the old bucket

The distance between the two magnets is 90mm and 29mm respectively

Hardware required as follows

608 bearing ×1. Used in the center of the turntable

M6*12*8 heat-set insert nut *1. Used on the base

M8*8-M6 hex socket shoulder screw *1. Used to connect the bearing and the base

M5*8*7.5 heat-set insert nuts 4 pieces. Used to connect the magnets and the turntable

M5*12*9 countersunk hex socket screws 4 pieces. Used to connect the magnets and the turntable

Diameter 30MM round perforated magnets M5 hole. Thickness 3-6MM is fine. Recommended to buy 3MM. If the thickness is insufficient, they can be stacked. 4 pieces are needed