Eye with tear

Print with 100% infill at a layer height of 0.08mm and a base layer of 0.16mm

The model is 200x200mm
 

Filaments used:
    PLA PolyLite Black Flow ratio: 0.3
    PLA BambuLab Basic Slate Gray Flow ratio: 3
    PLA PolyLite Gray Flow ratio: 1
    PLA PolyLite White Flow ratio: 5
This print uses 4 unique filaments

Change instructions:
    Start with Black
    At layer #8 (0.72mm) change to Slate Gray
    At layer #13 (1.12mm) change to Gray
    At layer #20 (1.68mm) change to White for the rest

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA BambuLab Basic Blue Gray Transmission Distance: 3
    PLA PolyLite Grey Transmission Distance: 1
    PLA PolyLite White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #8 (0.72mm) swap to Blue Gray
    At layer #13 (1.12mm) swap to Grey
    At layer #20 (1.68mm) swap to White for the rest.