M3 Nut Insulator | Prevent ESC Shorts
Print Profile(1)
Description
In many FPV builds, the high-voltage ESC power pads sit dangerously close to the metal stack hardware. A hard crash or frame flex can easily cause a short-circuit against a conductive M3 nut, instantly frying your electronics.
These M3 Nut Covers provide a physical, non-conductive barrier between your battery leads and your frame hardware. They are a must-have for tight builds where the ESC pads overhang the stack screws.
Features
- Low Profile: Fits in the tiny gap between your frame and ESC.
- Friction Fit: Snaps securely over standard M3 countersunk nuts.
- Safety: Prevents shorts from carbon fiber splinters or solder bridges.
Installation & Print Tips
- Securing: A small drop of B-7000 glue or E6000 is recommended during installation to ensure the covers stay seated during high-vibration flights.
- Material: TPU
- Infill: 100%
- Layer Height: 0.16mm or 0.2mm
Installation Tip: Use a bright filament color (like the blue shown in the photos) to make it easy to verify your insulators are still in place during pre-flight checks!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)