QUARK LID | GOOD AND CHEAP QUARK LID

Our quark always went bad because there was no proper lid. I designed a simple slide-on lid.

Print time: approx. one hour
Filament usage: approx. 4.2m

Material: PLA White
Print Temp: 200°C
Bed Temp: 60°C
Layer Height: 0.2mm
Print Speed: 60mm/s
Wall Speed 30mm/s

Supports: yes/no (not necessary, but it might not fit perfectly if printed without supports. However, supports can be difficult to remove...)
Support settings: Density: 15%, Lines, Distance X/Y: 0.2mm

Originally uploaded to Printables in 2021.