My Hero Academia - Froppy MHA Hueforge

Up next in my series is the Rainy Season Hero: FROPPY! 💕🐸

(Call her Tsuyu.. 😜)

I'm thrilled with how this one turned out. It was a labor of love start to finish. 

I'll get right to it so you can start printing 😁

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 156.67x235mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.96mm and the Actual Thickness is 2.96mm

    #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
    #00358e PLA BambuLab Basic Blue  Transmission Distance: 4
    #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
    #00ae42 PLA BambuLab Basic BambuLab Green  Transmission Distance: 2
    #fce300 PLA BambuLab Basic Yellow  Transmission Distance: 6
    #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4

This print uses 6 unique filaments

(Pauses already programmed in for single AMS users at layers 15 & 18. Delete these if you have more than 1 AMS or if you're manually swapping colors without an AMS, then do your thing.👌)

*Single AMS Users - Assign BLUE and YELLOW to the same AMS slot. Assign GREEN and RED to the same AMS slot. Starting colors are BLACK/BLUE/WHITE/GREEN.

Swap Instructions:
    Start with Black
    At layer #6 (0.56mm) swap to Blue
    At layer #11 (0.96mm) swap to Jade White
    At layer #13 (1.12mm) swap to Black
    At layer #14 (1.2mm) swap to BambuLab Green
    At layer #17 (1.44mm) swap to Yellow
    At layer #20 (1.68mm) swap to Black
    At layer #21 (1.76mm) swap to Red
    At layer #26 (2.16mm) swap to Yellow
    At layer #30 (2.48mm) swap to Jade White for the rest.
 

I hope you love this one, I am over the moon with it. Thanks so much for checking it out, and for all the supportive and kind words regarding my prints so far!