Robin Minion — DC Crime Fighter Mashup Fanart

Holy filament, Batman — the Boy Wonder got miniaturized. Robin Minion brings Gotham's scrappiest sidekick to the Minion universe, complete with the iconic red tunic, yellow utility belt, and that unmistakable single-eyed goggle stare that says "I absolutely did NOT plan this." Display him solo on your desk or assemble the full AGW DC Crime Fighters crew alongside BatMinion, Flash Minion, and SuperMinion so far….

✨ Features

• Single-body print — no assembly, no components, prints in one go
• Full Robin costume sculpt — red tunic, "R" emblem, yellow utility belt, cape, and green gloves
• Expressive Minion face with signature open-mouth grin and goggle detail
• Stable flat-foot stance — no brim or raft needed
• Print single-color and paint, or go full multi-color with AMS 
• Two print profile options: PLA with PLA supports or PETG with PLA supports
• Part of the AGW Mashup Mayhem Collection — 10+ superhero Minion figures and a some villains…. still growing

Tips & Tricks

• Single-body simplicity: No assembly required — pull it off the build plate, remove supports, and it's done. Everything is printed in one piece.
• PETG showcase results: The higher layer adhesion of PETG gives the cape and tunic a smoother, more finished look — worth the extra material cost for display pieces
• PLA is perfectly fine for the casual print — just expect a few extra minutes on support cleanup around the vest and toolbelt.
• Scaling up? Switch to a 0.6 nozzle at 0.3mm layer height above 120mm — detail holds well and print time drops significantly